Messages From digitrax

 


----------------------------

#125065 Jan 28, 2008

Is there a way of seseting a DS44 to the default.



----------------------------

#125066 Jan 28, 2008

Since the only settings on the DS44 are the accessory addresses, you simply

need to follow the instructions for setting sequential addresses in the range of

1 to 4....

Disconnect the track power to the DS44, jumper the white wire to the

black wire, reconnect track power, use your throttle to send a switch command

to address 1, disconnect track power, disconnect the jumper to the white wire,

reconnect track power. The DS44 should now respond to switch commands to

addresses 1 through 4 which is the default setting.

Note: Don't shut power off at the command station for the power disconnect

after you jumper the white wire since Digitrax command stations will normally

send some switch commands on initialization that will be accepted as the

programming by the DS44.

Regards,

Jim Wirt

'44 Caddy: ---Links-Are-Forbidden---

From: Digitrax@yahoogroups.com [mailto:Digitrax@yahoogroups.com] On Behalf Of killerjean

Sent: Monday, January 28, 2008 1:13 PM

To: Digitrax@yahoogroups.com

Subject: [Digitrax] DS44 reset



Is there a way of seseting a DS44 to the default.


S
e
n
i
o
r
T
u
b
e
.
o
r
g